Eternal Rival -S RANK PLUS - Hybrid X -Fightstick Enclosure

$ 89.99
Comparison Table Mid Tier Plus Hybrid X
S Rank Plus Hybrid X
Side Walls 1 Layer 2 Layers
Structural Pillars 6 7
Color Plexi Allowed 1 1
Dimensions 15inx9in 15.25inx9.75in
Mounting Screws/Flush Mount Included Included
Top Layers
Bottom Layers 2 3


The Materials  

  • Gloss Black – A slick finish that looks very classy. Prone to fingerprints though.  
  • Matte Black- A flat black finish that is durable and finger print resistant.   
  • Gloss White – A slick finish that looks very classy. Cannot see finger prints.  
  • Clear – See through

What am I getting?  

You will be getting a disassembled fightstick/stickless that you will need to put together. Included will be a one in all general instructions guide almost similar to IKEA. No glue is needed. Just need a phillips screwdriver.  

What’s included:  

  • A panel with mounting holes for Brook PCB/ENCODER  
  •  PCB/ENCODER mounting hardware that work with Brook fighting boards. (M3)  
  • Joystick Mounting hardware.
  • Joystick Spacer depending on what Joystick you plan to mount  
  • Black Hardware for black cases, Silver for everything else  
  • All the necessary hardware  
  • Panels to assemble the fightstick  
  • Eternal Rival Neutruk Support


Available in options

Button Compatibility  

Snap in and screw on buttons are compatible with this case.  

Joystick Compatibility  

Case is compatible with any joystick with a flat bracket. Depending on what model joystick you have, the case will provide the proper mounting holes for your joystick.  

Utility Button Layout
Start Button on top button, 5 on the front panel


  • Dimension - 15inx9in~x3in~ (Comes in different Height)

Buttons Needed  

  • 12 - 30mm action buttons  
  • 6 – 24mm utility buttons 

    Laundry list of parts for a working fightstick for this case. (This is just a baseline list) sells kits with everything you need.  

    • BROOK PCB of your choice  
    • 20pin cable -  
    • TP/R3/L3 cable -  
    • Neutrik - Link (Brook PS4+ Audio and Brook Wireless doesn’t not require a neutrik, but you will need to get screws to mount its port since Brook does not provide it)  
    • Joystick Cable Extension connector (the 20pin connector to the joystick is a bit short) - Link  
    • Short printer cable (PCB to the Neutrik)  
    • Long Printer cable (Neutrik to Console)  
    • Don’t forget the Buttons and Joystick (Joystick must be a flat bracket)  
    • Hitbox Cable
    • For K Levers you will need this harness - Link 

    Wiring Tips
    • Directly connect the joystick to the screw terminal of the brook pcb
    • Directional button connects to 20pin harness via hitbox cable
    • Cut the tie straps off of the hitbox cable - Connect to corresponding directions
    • Place ground wires in efficient matter, the hitbox ground cable does not need to fit corresponding button. All buttons share the same ground daisy chain.



    You may also like

    Recently viewed